For£º
For Skoda Rapid 2017 years Before
For Skoda Spaceback 2017 years Before
Note:
For Skoda Fabia Before 2017 and 2017, Fabia needs to replace the fuse!
Feature:
1. Automatic headlight
Set the switch to AUTO and the light will automatically turn on/off when the ambient brightness is below/above the set value.
Three lighting modes:
A. Tunnel mode (reaction time: 1 second)
B. Normal mode (reaction time: 3 seconds)
C. Delay mode (reaction time: 5s)
2. Automatic fog light
Set the switch to AUTO, when the ambient brightness is lower/higher than the set value, the fog light/wide light on/off
3. Flameout mode
A. The low beam will continue to light after the flameout (time setting range: 0-60s)
4. Rapid response
It takes less than 1 second to automatically turn on the headlights.
5. Protect the battery
The car headlights will turn off automatically.
After the car is started, the light will illuminate after 3 seconds.
6. Unlock the lights
When the ambient brightness is low, the indicator/low beam will automatically illuminate. (Time setting range: 0-60s)
7. Restore factory settings
¡¼Coming Home Light¡½:
At night or in a dimly lit environment, the lights will automatically turn off after a delay of 20 seconds after the car is turned off, illuminating your way home.
¡¼Leaving Home Light¡½:
At night or in a dimly lit environment, Use the original car key to unlock remotely, the lights turn on in advance and turn off after 20 seconds, the unlocking light is on, it is convenient to find the car
¡¼Automatic switch lights¡½:
It will automatically turn on the lights when entering tunnels, garages and other dark places.
Exit tunnel. Garage Automatically turn off lights in bright places such as during the day
How to install the product?
1.Turn the switch of the original car to the O gear, press down hard,
2.turn right to the small light gear at the same time,
3.and pull out the switch after feeling stuck.
4. Replace it with a new switch
How to test after installation?
Tip: All functions are normal for testing in low light or at night (night/in garage)
1.Cover the sensor head with a thick towel (remember not to cover it with your hands)
(you don`t need to use a towel at night or when testing in the garage)
2. Set the switch to AUTO
3. Start the car, power on first, then ignite
4.The low beam light is automatically turned on
(if only the small light is on, please use a double towel to keep the sensor in dark conditions)
5.Turn off the car and get off, the lights will go out after a delay of 20 seconds
6.After the light is off, wait for one minute, press the remote control to unlock, the light will turn on again, and turn off after 20 seconds
7.The above functions are all realized, indicating that the DIY is successful!