|
aHR0cDovL2ZyZWVzaGlwLmNvLmty
- ÀÓÇÇ´ø½º: 4
- ÁÖÆļö ¹üÀ§(Hz): 1000-10000hz
- ¾Æ¿ô ÆÄ¿ö: 20
- Àü¾Ð: 12V
- ½ºÇÇÄ¿ À¯Çü: Æ®À§ÅÍ
- ºê·£µå À̸§: NoEnName_Null
- ±Ù¿ø: CN (Á¤Ç°)
- Ç°¸ñ À¯Çü: ½ºÇÇÄ¿
¡¼Speaker parameters¡½:
Rated power: 30w
Impedance: 4 ohms
Overall length: 108mm
Total tweeter height: 53mm
Base width: 80mm
Lead length: 60CM (special requirements can be lengthened, take a note and leave a message)
[Note]: The tweeter cannot be directly connected to the power amplifier, it must be divided by a frequency divider. Be sure to connect the treble output of the crossover, or connect a 2.2¥ìF-3.3¥ìF treble capacitor in series, otherwise it will be burned out, please pay attention to the positive and negative poles!
This super high-pitched is mainly used for the high-pitched complement of the audio. It has a magical effect on the lack of high volume, dimness, and poor expressiveness. It is especially suitable for the treble complement of full-frequency audio. After installing the super tweeter, you can immediately feel the width, depth and layering of the sound field. The whole sound field becomes lively, and the high-pitched fineness, air and ductility are fully integrated, enriching the details of the sound.
The original design of the tweeter is to put the drilled wiring on the top of the speaker into the box and connect the frequency divider. For convenience, we can directly place it on the top and wire it in the back junction box. The problem of the cable protruding from the base needs to be solved by DIY.
|
|
|
|
|