9Pcs 12V Car SUV Push Button Start Keyless Entry Engine Start Alarm System Push Button Remote Starter Stop Auto car alarm system
Parameters:
Product Name: Car Push Button Start System
Product Alias: keyless entry, remote start, one key start, keyless start, remote start, smart start, comfortable entry, one key ignition
Application: for 12V general purpose products like storage battery cars, vans, pickup truck, SUV, etc.
Operating Voltage: 12V ± 3V
Static Current: less than 10mA
Working frequency: 433 MHz
Features:
Car intelligent push button start system comes with the smart chip and a key to start and flameout the car, being convenient and simple to use.
PKE keyless entry & automatic sensor switch lock function. The automatic sensor will unlock the car when you are 2 m/78.74 inch near the car.
With the remote start / flameout, ten minutes countdown function.
The car is cool in summer, but warm in winter. No longer endure the uncomfortable car environment.
With the ID identification function. The remote controller can`t work normally when it comes to the ID identification.
Key operation:
Do not step on the brake, press the button to turn on the ACC sound, then press the ``on`` button on the dashboard to make the indicator light flash. And then press the button to cycle the operation.
Brakes the car, short press the button, the system ignition starts, and light is always on.
When the flame is turned on, the brakes are short pressed and the system is turned off.
Step on or not step on the brakes, press and hold, the system can let go after the ignition with the light always on.
Q&A :
1.How to find the ACC wire?
Please rearrange the 6P cable, after you twist the key to the first gear position (you can listen to music at this time), measure the line that has electricity on your original car is the ACC line.
2. For your 6p cable, but my original car is only 5p. what can i do ?
If your original car is a 5P line, the right connection is normally 1 power line, 1 ACC line, 2 ON lines, and 1 start line. If you didn`t follow this step, it means you got wrong installation. pls recheck it again. and pls remember 2 ON lines need to distinguish which is ON1 line and which is ON2 line. If the two ON lines are always charged at the time of startup, you need to connect the two ON lines in parallel.
3. How to tell the wire ON1 and ON2?
If you test these two ON lines at startup, one of the two that always has power is the ON1 line. And If the other one has instant power is the ON2 wire.
Packing list:
1 x Host
2 x Remote Control Handle
1 x Start Button
2 x Sensing Antenna
1 x Start Harness
1 x Detection Harness
1 x Restore Button
1 x Manual