Remote Battery Disconnect Switch 12 V Auto On Off Switch For Car Universal Isolation Relay Universal Car Battery Switch
Features:
1.A New good design product That is a More Convenient Car Battery Disconnect Switch System which can remotely master kill your car power
system,A Proper maintenance will extend and protect the battery and engine life
2. Remote operation,Comparing to traditional battery switch, this Remote Control Wireless Battery Switch Disconnect allows you to move the
trigger from under the hood to your hand so that you no need to frequently pick up the hood.
3.Come with 2 light and handy New Style Remote Control.You can even control it in your house,One button control on your dash for the whole car
power system, Remote Receiver Standby Current is very low (0.0005A),Universal for DC 12V Car,Truck,Camper Trailer,SUV,Van Small Truck,
Agricultural Vehicle ,Trike, Auto Off Road.
4. Integrated design, small size, avoid cumbersome wiring, convenient installation
5. In daily car use, there will be situations such as no power, discharge, leakage, and power loss when starting the vehicle. The reason is that various electrical equipment in the car silently use too much battery power, which shortens the battery life. This product is installed behind the positive or negative pole of the car battery, and the battery is powered off through the remote control switch, which solves the above troubles of the majority of drivers.
Product Features:
Main functions: remote control of power off or power on of automobile battery.
Installation Tips: it is applicable to all brands of vehicles. This product needs professional auto
electrician to install.
Intelligent mode: This product provides automatic mode and remote control mode.
I) Automatic mode: when the battery voltage is lower than 12.2V, the power will be
cut off automatically after 3 minutes. When the voltage is 12.2v, the power will be
cut off automatically if the voltage does not reach 13.2v within 3 minutes after the
remote control is turned on. After starting the car, the voltage is higher than 13.2v,
and the remote controller does not work to prevent the battery from being
disconnected due to the false triggering of the driving state.
below 13.2v can be turned on and off at any time. Press the lock button of the remote once, the relay can be started
normally when it is powered on. Press the unlock button on the remote once, the power supply of the whole vehicle
will be disconnected.
II) Remote control mode: press the lock button of the remote control once, turn on the power, and it can be started
Normally. Press the unlock button on the remote control once, and the power supply of the whole vehicle will be
disconnected. This mode does not detect voltage and does not automatically cut off power.
III) The factory defaults to the automatic mode, The default state is on, which can be started normally.
IV )Mode conversion: long press the lock button of the remote control for 5 seconds and then turn to the automatic
mode. Long press the unlock button for 5 seconds and then turn to the remote control mode. Power on after power
failure to restore automatic mode.
SPECIFICATION
Working voltage: DC 9-15v
Rated current: 200A
Instantaneous current: 500A
Standby current: 0.005A
Installation method:
1. Open the engine cover and find out the positive and negative poles of the battery
2. Generally, the negative pile head is selected to install the breaker and judge the
space position where the unit can be placed remove the negative pile head hoop
3. Install the fitting connecting piece and pile head hoop on the screw column of
the host, regardless of left and right (as shown in the right figure)
4. Screw the pile head hoop of the breaker onto the negative pile head,
and connect the connecting piece with the battery pile just removed
Tighten the head hoop with screws
4. Plug in the power cord. The red wire fork is connected to the positive
pole of the battery, and the black wire fork is connected to the negative
pole of the battery To supply power to the unit, the power consumption
is 2.4W, and the power consumption is less.
Package Include
Unit*1; Remote controller*2; Pure copper pile head *1aluminum alloy hoops (one positive and one negative)*2;
Copper connecting pieces*2; Instructions Manual*1